Hyundai Santa Fe: Rear Door Belt Outside Weatherstrip. Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Santa Fe: Rear Door Belt Outside Weatherstrip. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Outside Weatherstrip. Repair procedures

Replacement

1.
Pull down rear door window glass by pressing the power window glass switch.
2.
After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Rear Door Latch. Repair procedures
Replacement 1. Remove the rear door module. 2. Remove the rear door outside handle base (A) by pushing in the lock pins located in the back. 3. Remove the rear door outside handle base cable (A). 4. Open ...

Rear Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

See also:

If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. 2. Turn on your emergency flashers. 3. Try to start the engine again. If your vehicle will not start, ...

To defrost outside windshield
1. Set the temperature to the extreme hot (HI) position. 2. Set the fan speed to the highest (extreme right) position. 3. Press the defrost button (). 4. The outside (fresh) air position will be selected ...

Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solenoid ...