Hyundai Santa Fe: Rear Door Latch. Repair procedures
Replacement
| 1. |
Remove the rear door module.
|
| 2. |
Remove the rear door outside handle base (A) by pushing in the
lock pins located in the back.
|
| 3. |
Remove the rear door outside handle base cable (A).
|
| 4. |
Open the rear door outside handle cable cap (A).
|
| 5. |
Remove the rear door outside handle cable (B).
|
| 6. |
Disconnect the rear door latch connector (B).
|
| 7. |
Remove the rear door latch assembly (A) by pulling it.
|
| 8. |
Remove the rear door inside handle cable (A) by pulling it.
|
| 9. |
Install in the reverse order of removal.
|
Rear Door Latch. Components and Components Location
Component Location 1. Rear door latch ...
Rear Door Belt Outside Weatherstrip. Repair procedures
Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A). 3. Install in ...
See also:
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...
Schematic Diagrams
System Block Diagram Component Parts And Function Outline Component part Function Vehicle-speed sensor Converts vehicle speed to pulse. ECM Receives signals from sensor and control switches. Cruise control ...
Hood Insulator Pad. Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). • Be careful not to scratch the hood panel. 2. Install in the reverse order of removal. • Replace any damaged ...
