Hyundai Santa Fe: Rear Door Belt Inside Weatherstrip. Repair procedures
Replacement
| 1. |
Remove the rear door trim.
|
| 2. |
Remove the rear door belt inside weatherstrip (A).
|
| 3. |
Install in the reverse order of removal.
|
Rear Door Belt Outside Weatherstrip. Repair procedures
Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A). 3. Install in ...
Rear Door Side Weatherstrip. Repair procedures
Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the rear door side weatherstrip (A). ...
See also:
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Knee Airbag (KAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. 3. After loosening the mounting nuts and then remove the ...
