Hyundai Santa Fe: Repair procedures - Cowl Top Cover - Body (Interior and Exterior)Hyundai Santa Fe: Repair procedures

Replacement

1.
Remove the cap (A) and remove the nuts, then remove the wiper arm (B).

Tightening torque :
22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)

2.
Detach the clips, then remove the fender side cover (A).

3.
Remove the glue on end of both sides (A) of the hood weatherstrip.

4.
Disconnect the nozzle hose (B).
5.
Detach the clips, then remove the cowl top cover (A).

6.
Install in the reverse order of removal.
•
Replace any damaged clips.

Components and Components Location
Component Location 1. Cowl top cover ...

See also:

Rear Washer Motor. Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign material or contamination. ...

Outside rearview mirror
Be sure to adjust mirror angles before driving. Your vehicle is equipped with both left-hand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch. The mirror ...

General Tightening Torque Table
General Tightening Torque Table Bolt nominal diameter (mm) Pitch (mm) Torque Nm (kg.cm, lb.ft) Head Mark 4 Head Mark 7 M5 0.8 3 ~ 4 (30 ~ 40, 2.2 ~ 2.9) 5 ~ 6 (50 ~ 60, 3.6 ~ 4.3) M6 1.0 5 ~ 6 (50 ~ 50, ...