Hyundai Santa Fe: Schematic Diagrams - General Information - Emission Control SystemHyundai Santa Fe: Schematic Diagrams

Schematic Diagram


Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or stuggle to start Vapor hose damaged or disconnected Engine stuggle to start Malfunction of the Purge Control Solenoid Valve Rough idle or engine ...

Components and Components Location
Components Location 1. PCV Valve 2. Canister 3. Purge Control Solenoid Valve (PCSV) 4. Fuel Tank Pressure Sensor (FTPS) 5. Canister Close Valve (CCV) 6. Fuel Level Sender (FLS) 7. Fuel Tank Air Filter ...

See also:

Rear seat folding from outside
Pull the rear seat back folding lever out. The rear seat back will be folded. If you pull the left side lever (1) out, left side seat back and center seat back will be folded. If you pull the right side ...

License plate lamp bulb replacement
1. Loosen the lens retaining screws with a screwdriver. 2. Remove the lens. 3. Remove the bulb. 4. Install a new bulb. 5. Reinstall the lens securely with the lens retaining screws. ...

Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds. 2. Release ...