Hyundai Santa Fe: SS-B Solenoid Valve(ON/OFF). Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: SS-B Solenoid Valve(ON/OFF). Description and Operation

Description

SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body.


SS-A Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

SS-B Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω) 10~11 ...

See also:

Front Seat Belt Buckle. Repair procedures
Replacement 1. Remove the front seat assembly. 2. Disconnect the front seat belt buckle connector wiring (A). 3. After loosening the mounting nut, then remove the front seat belt buckle (A). Tightening ...

Propeller Shaft. Repair procedures
Removal 1. After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A). Tightening torque: 49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft) 2. Remove ...

Alternator. Specifications
Specification Alternator Item Specification Rated voltage 13.5V, 130A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below ...