Hyundai Santa Fe: Front Seat Shield Inner Cover. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe: Front Seat Shield Inner Cover. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Inner Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
2.
After loosening the mounting screw, then remove the front seat shield inner cover (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Front Seat Shield Inner Cover. Components and Components Location
Component Location 1. Front seat shield inner cover ...

Front Seat Back Cover. Components and Components Location
Component Location 1. Front seat back cover ...

See also:

Engine Control Module (ECM). Schematic Diagrams
ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart key type] Ignition Coil (Cylinder ...

Accelerator Position Sensor (APS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification: Refer to “Specification” ...

High Mounted Stop Lamp. Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. 3. Remove the high mounted stop lamp assembly (A) after loosening screws (4EA). Installation ...