Hyundai Santa Fe (DM): Front Seat Shield Outer Cover. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Seat Shield Outer Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat shield center cover (A) as direction of the arrow.

2.
After loosening the mounting screw, then remove the front seat shield outer cover (A).

3.
Disconnect the connectors (A).

4.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Seat Shield Outer Cover. Components and Components Location
Component Location 1. Front seat shield outer cover ...

Front Seat Shield Inner Cover. Components and Components Location
Component Location 1. Front seat shield inner cover ...

See also:

Master Cylinder. Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. 3. Disconnect the brake fluid level switch connector (B), and remove the reservoir ...

Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Inspect the PCV vlave operation. (1) Run the engine at idle. ...

Differential Carrier Assembly
Components and components location Components Location 1. Rear differential carrier assembly 2. Rear driveshaft assembly 3. Coupling Assembly 4. Propeller shaft assembly Components 1. Pinion lock nut 2. ...