Hyundai Santa Fe: Fuel Sender. Repair procedures
Removal
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
| 2. |
Disconnect the fuel sender connector (A).
|
| 3. |
Release the fixing hooks, and then remove the fuel sender (A).
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Pump Motor. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...
Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...
See also:
Accelerator Position Sensor (APS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification: Refer to “Specification” ...
Front Door Window Glass. Repair procedures
Replacement 1. Remove the front door trim. 2. Remove the front door belt inside weatherstrip (A). 3. Remove the front door window glass mounting hole plug (B). • Be careful not to drop the glass and/or ...
Special Service Tools
Special Service Tools Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture(Beam) Removal and installation of the transaxle. Except lower supporter, use beam only with new engine ...
