Hyundai Santa Fe: Hood Assembly. Components and Components Location
Component Location
|
1. Hood assembly |
Repair procedures
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjust the hood height by turning the hood overslam bumpers (C). 3. After loosening ...
Hood Assembly. Repair procedures
Replacement • Be careful not to damage the hood and body. • When removing and installing the hood, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, ...
See also:
DBC Switch. Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the crash pad side switch assembly (A) after loosening the screws. 4. ...
Components and Components Location
Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch/Disk type) 3*. Horn (Low pitch/Shell type) 4. Horn (High pitch/Disk type) 4*. Horn (High pitch/Shell type) 5. ...
Rear Spoiler. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
