Hyundai Santa Fe: Rear Door Side Weatherstrip. Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Santa Fe: Rear Door Side Weatherstrip. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Side Weatherstrip. Repair procedures

Replacement

1.
Loosen the rear door checker (B) mounting bolt.
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft)
2.
Detach the clips, then remove the rear door side weatherstrip (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Rear Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

Body Side Molding
...

See also:

Wheel. Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should be checked using ...

Special Service Tools
Special Service Tools Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture(Beam) Removal and installation of the transaxle. Except lower supporter, use beam only with new engine ...

Front fog light
Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc. 1. Turn on the park light. 2. Turn the light switch (1) to the front fog light position. 3. To ...