Hyundai Santa Fe: Fuses And Relays
Outside lamp Input Speed Sensor. Repair procedures Steering Column Shroud Panel. Components and Components Location
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...
Fuel Filler Door Open Switch. Repair
procedures
Component Location 1. Power outlet relay 2. Start relay 3. Front deicer relay 4. Blower relay 5. Wiper relay (Low) 6. ACC relay 7. IG1 relay 8. IG2 relay 9. Cooling fan relay 10. Wiper relay (High) 11. ...
Components and Components LocationSee also:
1. Open the tailgate. 2. Remove the service cover using a flat-blade screwdriver. 3. Loosen the lamp assembly retaining please verify. 4. Remove the rear combination lamp assembly from the body of the ...
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...
Component Location 1. Steering column shroud lower panel 2. Steering column shroud upper panel ...
