Hyundai Santa Fe (DM): Intake And Exhaust System - Engine Mechanical SystemHyundai Santa Fe (DM): Intake And Exhaust System

Oil Level Gauge & Pipe. Repair procedures
Removal and Installation 1. Remove the oil gauge(A). 2. Remove the intake manofold. 3. Remove the oil level pipe(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Install in ...

Air Cleaner. Components and Components Location
Components 1. Air duct 2. Air cleaner body 3. Air cleaner element 4. Air cleaner cover 5. Air intake hose 6. Clamp ...

See also:

Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...

Components and Components Location
Components Connector Pin Information No. Connector A Connector B Connector C Connector D 1 IGN1 Head lamp low switch Wiper low relay Room lamp 2 ACC Auto light switch Burglar alarm relay Cornering lamp ...

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace Defective front suspension and ...