Hyundai Santa Fe: Starting System
Repair procedures Vehicle certification label General Information
Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the battery negative (-) cable after removing the bolts (B). Installation 1. Install in the ...
Battery Sensor. Repair procedures
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...
Description and OperationSee also:
Inspection 1. Remove the cowl top cover. 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition ...
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...
General 1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending. 3. For measuring dimensions, ...
